Although the battery for forklifts is said to be a deep cycle discharge battery, if the power is lost in the past, the plate vulcanization will be accelerated. The low efficiency of the battery pack for forklifts is caused by the frequent high current discharge. The forklift itself has a limit of 1.5 tons. 1.5 tons or close to 1.5 tons, the depth of discharge has a great influence on the service life of the forklift battery. The deeper the discharge depth of the forklift battery, the less the number of cycles used, although the small current discharge can improve the efficiency of the electric forklift battery, but When discharging with a very small current for a long time, it will cause the actual discharge capacity of the battery for the forklift to exceed its rated capacity, resulting in serious deep discharge of the electric forklift battery. When the discharge depth of the electric forklift battery is the limit, it is necessary to avoid long time and light. The discharge discharge causes the forklift battery to be deeply discharged, and it is necessary to avoid short-circuit discharge of the forklift battery. Otherwise, it will seriously damage the recharging capacity and storage capacity of the forklift battery and shorten the service life; a group of forklift batteries are calculated according to 1500 cycles. If the long-term depth is high current discharge, the life is at least Cut in half.

The battery for forklifts is an open-filled battery. It is not maintenance-free. It is currently not in the battery industry. It has not yet developed a maintenance-free valve-controlled forklift truck battery. This type of open battery needs to be added regularly, if the workload is large. Or if the charging current is too large, then the amount of liquid consumption is very fast each time, then what should we do if we standardize the dosing battery? According to years of experience, when adding distilled water, it can be 10 to 15 mm higher than the plate. If there are two red wires, the electrolyte should not exceed the upper red line. If the electrolyte is too full, it will overflow from the small hole in the battery cover. The electrolyte is electrically conductive, and once it flows between the positive and negative electrodes of the battery, a self-discharge of the circuit is formed. In this case, the electrolyte should be wiped off or rinsed with boiling water.

If something accidentally falls into the electrolyte, do not use metal objects to fish, use wooden sticks to remove impurities; if you use iron wire or copper wire to fish, metal molecules will enter the battery under the attack of sulfuric acid to form self-discharge. When the battery is damaged, during the charging and discharging process, the water in the electrolyte will gradually decrease due to electrolysis and evaporation, resulting in a decrease in the electrolyte surface. If it is not added in time, it is possible to shorten the service life of the battery. The distilled water should be added in time, and it should not be replaced by drinking pure water.